Sylvan Glen Roofing

Roofing

Flat Roof Replacement in Troy, MI

Flat roof replacement services built for Troy's cold winters, mature trees, and 1960s-1990s homes with second or third layers.

  • ✓Mon-Fri 9am-9pm, Closed Weekends
  • ✓Roof Replacement & Repair
  • ✓Troy & Southeast Oakland County

Request a Callback

Tell us about your roof problem and a local technician will call you back.

Flat roofs on Troy additions and garages often fail from ponding water that turns to ice during freeze-thaw cycles, lifting seams and forcing moisture under the membrane. Mature trees along Rochester Road Corridor and Big Beaver drop debris that clogs drains, while strong winds tear at edges near the Somerset Collection area. Homeowners in subdivisions with HOA rules frequently discover curling or failed modified bitumen after the second or third layer has been left in place.

We start every flat roof replacement with a deck inspection that checks for rot around valleys and pipe boots, then perform a full tear-off to expose the substrate. New ice and water shield goes down at all perimeters and penetrations before the chosen membrane is installed with proper step flashing and ridge vent integration where the flat section meets sloped roofing. Soffit intake is verified to maintain airflow and reduce future ice dam risk.

Southeast Oakland County winters combine heavy snow load with sudden thaws that drive water under old EPDM or modified bitumen seams. We address this by removing every layer down to the decking, replacing damaged sections, and adding upgraded underlayment that handles both wind-driven rain and hail common near Oakland Mall and Troy Historic Village.

Technician insight

In Troy, the thing that catches most people out with flat roof replacement is discovering the deck has rotted under three layers of old modified bitumen right where the flat section meets the house wall. Freeze-thaw cycles along the Rochester Road Corridor push water under seams faster than homeowners expect, especially on 1970s ranches with limited slope.

Addition Flat Roof After Ice Dam

Water entered a 1980s colonial addition near Somerset after repeated ice dams lifted the old EPDM seams. We found saturated decking under two prior layers. After complete tear-off and deck repair we installed new modified bitumen with upgraded perimeter shielding. The homeowner reported no further leaks through the next winter.

Flat Roof Replacement Services We Offer

✓EPDM Membrane Replacement

Full removal and new EPDM installation that seals seams against ice dam pressure and wind uplift common on Troy flat sections.

✓Modified Bitumen Flat Roof Replacement

Torch-down or self-adhered modified bitumen systems installed after complete tear-off to handle repeated freeze-thaw movement on local additions.

✓TPO Roof System Installation

Heat-welded TPO membrane applied over new underlayment to reflect heat and resist ponding water in southeast Oakland County subdivisions.

✓Drainage and Gutter Integration

Re-sloping and new leader lines added during replacement to move water away from flat areas before it reaches soffit intake or foundation.

✓Deck Repair During Tear-Off

Replacement of rotted or damaged decking discovered once layers are removed, preventing future leaks around step flashing and valleys.

How it works

  1. 1

    On-Site Assessment

    We examine membrane condition, check for granule loss or seam separation, and note how many layers exist before any work begins.

  2. 2

    Complete Tear-Off

    All existing roofing is removed down to the deck so we can inspect for rot and install fresh ice and water shield at every critical point.

  3. 3

    Membrane and Detail Work

    New EPDM or modified bitumen is laid with proper pipe boots, step flashing, and ridge vent tie-ins where the flat area meets pitched roofing.

  4. 4

    Edge and Drainage Finish

    Drip edge, gutters, and soffit intake are adjusted or replaced to ensure water moves off the roof before freeze-thaw cycles begin.

Tools and Methods We Use

Heat welder

Fuses TPO seams into a single watertight sheet. A properly welded seam is stronger than the membrane itself.

Roofing nail gun and air compressor

Fastens cover board and insulation to the deck at the correct pattern and depth per manufacturer spec.

Pry bar and shingle cutter

Removes old membrane, flashing, and termination bars during tear-off without damaging the deck.

Chalk line and utility knife

Lays out membrane cuts and flashing lines so every sheet is square and every seam lines up.

Safety harness and ladder stabilizer

Keeps our crew tied off and the ladder secure on every low-slope roof, per OSHA and MIOSHA rules.

Magnetic sweeper

Runs the lawn and driveway at the end of every job to pick up nails and staples before we leave.

Sylvan Glen Roofing — roofing in Troy

Good to know

Flat Roof Replacement — FAQs

Still have questions? We're happy to talk it through.

(248) 555-0142
+ How do you handle ice dams on flat roofs in Troy?
We remove every layer, install continuous ice and water shield at edges, and verify drainage so melt water does not back up under the new membrane.
+ Can you replace just the membrane or do you always do a tear-off?
We always perform a full tear-off on flat roof replacement so the deck can be checked and new underlayment applied without trapping old moisture.
+ What membrane works best for southeast Oakland County winters?
Both EPDM and modified bitumen perform well when installed over fresh ice and water shield and tied correctly into existing ridge vent and soffit intake.
+ Do HOA rules affect flat roof work in subdivisions?
We match existing profiles and colors so the finished roof stays within typical Troy subdivision guidelines without adding visible changes.

Business hours — Mon–Fri 9am–9pm

Need Roof Replacement in Troy, MI?

Talk to a local roof replacement company serving Troy and nearby neighborhoods. Workmanship you can inspect for roof replacement and repair.

Call now Request a callback